FONESTAR MXZ-2036 Manual Del Usuario página 5

1.-
POWER 24 V DC: socket for 24 V DC power supply connection. The model MXZ-2036 mixer supplies power via
the cat 5e cable. The 24 V DC external power supplier must be connected if the distance is over 50 m.
2.-
VOLUME: control for regulating the output volume.
3.-
TREBLE: reinforces or attenuates the treble frequencies ±10 dB.
4.-
BASS: reinforces or attenuates the bass frequencies ±10 dB.
5.-
CHIME VOLUME: chime volume control.
6.-
ID CONSOL: microphone number configuration switches (from 1 to 6). If more than one microphone in the
system is being used, a different number must be selected for each microphone.
7.-
LINE IN: data and audio line input connector from the mixer model MXZ-2036.
8.-
LINK OUT: output connector for connecting the following microphone with zone selector model M-203.
INSTRUCTIONS FOR USE
CONNECTION OF MICROPHONE M-203
For the connection of microphone mod. M-203 a Cat.5 type cable is used. This cable is connected to the REMOTE MIC
output of the mixer mod. MXZ-2036 and to the LINE IN input of the first microphone mod. M-203.
In the event of having more than one microphone they should be connected in cascade from the LINK OUT output of
the first to the LINE IN input of the second and so on.
CHIMES
The chimes can be used in two ways:
- The chimes can be played remotely through the microphone mod. M-203. Select the zone or zones to which you
wish to send the chimes using the buttons ZONE 1 to 6. Then, press the TALK button which activates the chimes
and open the microphone to page in the selected zones.
- To play the chimes from the amplifier, they must be activated on the rear panel using the PRIORITY contact closure.
Closing these contacts activates the chimes and attenuates the level of the auxiliary input (AUX 1, AUX 2 o AUX 3)
in the zones that are selected. These inputs will remain attenuated as long as the contacts are closed.
INPUT PRIORITY
The priority function automatically reduces the level of the inputs with lower priority so that the paging or message
broadcast through those with higher priority can be clearly heard.
The input signal for the microphone mod. M-203 has maximum priority over the rest of the inputs and is activated when
the TALK button on the microphone is pressed. When the priority is activated, the MIC inputs, messages 1 or 2 and the
auxiliary input (AUX 1, AUX 2 o AUX 3) are automatically attenuated, so that the message is clearly heard.
In the next priority level message 3 is found, which is activated by pressing the ALARM button on the microphone
mod. M-203 for approximately two seconds. This input has priority over the MIC inputs, messages 1 and 2 and the
auxiliary input (AUX 1, AUX 2 o AUX 3), which will remain attenuated as long as the message is active or PRIORITY
contact closure is closed.
Mic number Switch configuration
1
ON
2
ON
3
ON
4
ON
5
ON
6
ON
- 5 -
EN