Metal Grease Filter; Long-Life Anti-Odor Filter (For Filtering Hoods); Hood Cleaning; Lighting - Galvamet SILENZIO Instrucciones De Instalación, Uso Y Mantenimiento

VI.1 Metal grease filter
Particular attention should be paid to the metal grease filter, which has the function of retaining the fat particles
contained in the vapors. The grease filter must be washed when the warning appears or at least once a month, use hot
water and detergent (or put it in the dishwasher). The filter may become discolored after a few washes. This is normal
and does not mean that it needs to be replaced.
To carry out maintenance on the grease filter, it is essential to remove it from the hood. With the hood turned off, the
condensation collection tray must be opened and the filter removed by its handle (Fig. 6.1.1). At this point, you can
proceed with the filter cleaning. It is recommended to reinsert the grease filter only when it is perfectly dry.
ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely
important to clean the metallic filters regularly as per instructions
VI.2 Long-Life anti-odor filter (for filtering hoods)
The Long-Life anti-odor filter, where present, captures all the odors present in the cooking fumes, guaranteeing pure
air in your kitchen. It does not have to be replaced frequently like an ordinary activated charcoal filter, it can be
regenerated every 3-4 months, or according to the frequency of use of the hood, by a normal washing cycle in the
dishwasher at about 70°C without any type of detergent, followed by drying in the oven for 30 minutes at 70°C. To keep
its efficiency high, it is recommended to replace the Long-Life filter after 6/8 regeneration cycles.
To replace the Long-Life anti-odor filter simply remove the metal grease filter (Fig. 6.1.1) and slide the frame enclosing
the anti-odor filter towards the rear (Fig. 6.2.1). Take the frame including the Long Life anti-odour filter and regenerate
it (Fig. 6.2.1-A). The filter must be requested to the manufacturer. To install a new Long-Life anti-odor filter, remove
the metal grease filter (fig. 6.1.1), place the new Long-Life anti-odor filter on top and slide it to hook it to the metal
filter. Reinstall the metal grease filter.
VI.3 Hood Cleaning
The hood must be cleaned immediately after installation and removal of the protective film to eliminate any residual
adhesive or other impurities. The hood must be cleaned frequently both internally and externally (at least once a month).
Do not allow dirt to accumulate on the surfaces of the hood.
Do not use acid or basic products or abrasive sponges to clean the external parts of the hood. Clean the hood with a
sponge moistened with hot water and a small quantity of neutral soap (for example dish soap) to eliminate any grease
particles that may have deposited.
Rinse with a damp cloth, carefully remove all the soap, following the direction of the satin finish of the steel surface.
Drying is particularly important, especially in areas where the water is very hard and leaves limescale deposits.
VI.4 Lighting
The hood is equipped with LED lighting which, in addition to offering excellent lighting and limited energy consumption,
guarantee a considerable duration over time. Both the brightness and temperature of the hood's LED lighting be adjusted
(see the OPERATION section).
VII DISCONTINUATION
The discontinuation means the definitive shutdown and disassembly of the appliance.
After discontinuation, the appliance can be installed on another piece of furniture, privately resold, or disposed of.
Caution! For discontinuation, it is necessary to switch the appliance off and disconnect the power
Disassembly requires that the device is accessible and has been disconnected from the power supply.
To do this, follow the installation instructions in reverse order.
This appliance is marked under the European Directive 2012/19/EC, Waste Electrical and Electronic
Equipment (WEEE).
The symbol on the product or the packaging indicates that the product should not be considered as
normal household waste, but must be taken to the appropriate collection point for the recycling of
electrical and electronic equipment.
The appropriate disposal of this product helps to avoid potential negative consequences for the
environment and health. For more detailed information, contact your local office, local waste disposal
service, or the shop where you purchased the product.
12