NuWave INFINITY 28202 Manual Del Propietário página 8

QUICK START
Notes:
• When blending for a long period of time liquids may become
hot and steam may escape from the Plunger Cap.
Use the numbered settings. Default time is 3 min.
For standard blending you can select from one of the numbered
speed settings between 1 and 10. Adjust to desired time, then press
Start/Pause to begin blending.
Note: The lowest setting is #1 (5,000 RPM). The highest setting is
#10 (17,000 RPM).
Icon settings are for specialized blending tasks. Each icon
setting has default time and RPM built in.
Turn the dial to desired icon setting and press Start/Pause to
begin blending.
Note: Always start with cold liquids when blending. DO NOT add
hot liquids to the Infinity Blender.
™
Cleaning your Infinity Blender Jar:
™
Add water and 1-2 drops of liquid dish soap to your Jar, place on
the Base, and close the Lid. Turn the dial to Clean. 00:15 will be
shown on the LED display. Adjust the time if desired, and then
press Start/Pause. Once finished, remove the Jar, rinse thoroughly,
and dry before using.
Note: For detailed instructions on cleaning refer to "Cleaning &
Maintenance."
14
quick start
INSTRUCTIONS
Getting Started
Turn the red main Base Power Switch ON. Switch is located on
1.
the right side of Blender Base.
The Power button will flash.
•
Press Power button once to turn your Infinity
2.
LED display will show the default time for the selected setting.
Turn the dial to choose your appropriate blending function.
3.
Press Start/Pause to start blending.
4.
Press Start/Pause again to stop blending.
5.
Press the Power button again and press the red main Base
6.
Power Switch OFF to turn your Infinity
Time Setting
Press the up and down arrows on your Infinity
Blender to increase or decrease the time on the
display.
Times are displayed in minutes and seconds.
•
Blending times can be adjusted when using
•
any setting.
Example:
Press Power button. Turn dial to Ice. 00:15 (15
seconds) will be displayed. Press up and down arrows to adjust the
time. Press Start/Pause.
Numbered Settings
For standard blending you can select your blending speed from one
of the numbered settings from 1 to 10.
Turn the dial to your desired settings from 1 to 10.
1.
Adjust the time, if desired, then press Start/Pause to begin
2.
blending at your selected setting.
Adjust the number setting using the dial at any point while
3.
blending, if needed.
Pulse Function
The Infinity Blender offers two Pulse functions where the power
™
settings are fully adjustable.
1. Press Pulse 1 for short bursts of blending at low power (25%
Power).
Press and hold Pulse 1 for continuous blending. Once the
•
button is released, blending will end.
Blender on. The
™
Blender off.
™
™
00:15
15
nuwavenow.com