FONESTAR MA-245Z Manual De Instrucciones página 5

EN
CONNECTION
Make the connections with the amplifier and all the components of the audio system switched off and
disconnected from the power supply.
Firstly, connect the audio sources to the inputs. Connect the loudspeakers to the loudspeaker outputs. Use
the 4 Ω low impedance output or the 100, 70 or 25 V high impedance lines, according to the type of
loudspeakers you are going to connect. Do not use both types of output at the same time.
If using the low impedance output, you must connect the loudspeakers in a series/parallel circuit so that the
load impedance of the loudspeakers is the same as the amplifier output impedance and that the power
supplied by the amplifier does not exceed that withstood by the loudspeakers.
If you using a 100, 70, or 25 V high impedance line output, you must connect all the loudspeakers in parallel
and the sum of the power of all the loudspeakers must not exceed the power supplied by the amplifier.
Once the connections have been made according to your needs, connect the system to the mains and turn
it on. After use, do not forget to switch the device off and disconnect it from the mains.
- 5 -