3. Close the hatch
place.
The filter is inserted.
Placing the device in the pool and starting cleaning
The device can hurt persons in the pool.
- Make sure no one is in the pool while the device is in the water.
1. Hold the device by the handle and
lower it slowly into the water until all
the air has escaped. The device should
run at a right angle to the pool wall.
2. Turn on the ON/OFF switch
3. Then let the device sink to the bottom
of the pool.
The device is in the pool and starts cleaning
with a time delay. The status indicator
blinks blue.
Switching off the device
Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
so that it locks in
7
Risk of injury!
.
6
4
4
CAUTION!
5
6
6
7
4
35