Replacing The Air Cleaner - Toro HoverPro 550 Machine Manual Del Operador

Figure 32
4. Close the fuel-shutoff valve; refer to
Valve (page 13).
Important:
If you are repairing the machine,
empty the fuel tank.
5. After performing the maintenance procedure(s),
open the fuel valve and connect the spark-plug
wire to the spark plug.

Replacing the Air Cleaner

Service Interval: Yearly
1. Press down on the latch tabs at top of the
air-filter cover
g017342
Fuel Shutoff
1. Latch tabs (air-filter cover)
2. Filter element
2. Remove the cover.
3. Remove the filter element
4. Inspect the paper air filter.
A.
B.
5. Clean the air-filter base and cover using a moist
rag. Do not wipe dirt into the air duct.
6. Insert the filter into the filter base.
7. Install the cover.
19
(Figure 33).
Figure 33
3. Air-filter base
(Figure
If the filter damaged, wet with oil or fuel, and
excessively dirty, replace it.
If the filter is dirty, tap it on a hard surface
several times or blow compressed air less
than 207 kPa (30 psi) through the side of
the filter that faces the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
g364771
33).