Frequently Asked Questions; Technical Data - GASLOCK gaslight GL-6001 Instrucciones De Uso

Frequently Asked Questions

EN
If you are not satisfied with the results, we hope that the following will
answer your questions and problems.
How do I switch the GASLIGHT
+ You can install a standard switch between the required 12 / 24 Volt line.
Important: The switch must not be located in the gas bottle locker.
+ You can take the required 12 / 24 Volt from the light control of your
caravan. This will mean that the GASLIGHT® will light up as soon as you
switch on the light inside your caravan.
What do I do if one or more of the LEDs on the GASLIGHT
malfunctions?
+ Never open the casing of the GASLIGHT®; contact our Service Desk.
Can I also use the GASLIGHT
+ Of course you do not have to install the GASLIGHT® in your gas bottle
locker. We provide an optional 230 Volt plug-in power supply unit for
installing your GASLIGHT® in a non-intrinsically safe area.
Can I also use the GASLIGHT
+ Because the GASLIGHT® is waterproof, you can also install it outdoors.
Please note that the power supply unit may not be installed outdoors
and must not come in contact with water.
Can I extend the cable between the light and the intrinsically
safe power supply unit?
+ The cable between the light and the intrinsically safe power supply unit
be extended to up to 13 meters (42.5 feet).
Can I use the light without the intrinsically safe power supply unit?
+ You can use the light without an intrinsically safe power supply unit using
a 5V DC supply. However, in this case the light should not be used in
areas where there is an explosion hazard.
16
®
on and off?
®
®
outside my gas bottle locker?
® outdoors?

Technical Data

Article No.
Light dimensions (LxWxH)
Dimensions of intrinsically safe
power supply unit (LxWxH)
Weight of lamp
Weight of intrinsically safe power
supply unit (LxWxH)
Input voltage for power supply unit
Maximum input current for power
supply unit
Output voltage of intrinsically
safe power supply unit
Short-circuit current for intrinsically
Safe power supply unit
Input voltage for light
Input current for light at 5 V
Maximum power supply for the light with
an intrinsically safe power supply unit
Light intensity
Test mark
GASLIGHT ®
GL-6001
140.7 x 18.2 x 7.8 mm
110.1 x 61.0 x 27.1 mm
85 g
72 g
10 - 30 V DC
350 mA
4,7 V +- 5 %
< 2 A
4.0 - 5.5 V
400 mA
10 m
160 lm
Power-supply unit: EX ® II (2)G [Ex ib Gb] IIB
Light: EX II 2G Ex ib IIB T4 Gb
®
EN
17