Product Operation - Setting Up; Packing Up - Active TIGERCUT 25 Manual De Usuario

Product Operation - Setting Up

1. Insert the battery into the power connector of the pruner.
2. Switch on the power switch of the pruner. Due to rst time usage, the
LED display indicator will be green and the buzzer will sound 1 time.
3. Double click the trigger, the pruner blades will automatically open.
4. Normal pruning: press trigger to close the blades and release the trigger
Blade closing: continue to press the trigger; a continuous buzz means that
the blades will stay closed.
5. Before operation, in order to check if the pruner is working properly, please
press the trigger to close and release the trigger to open the blades without
cutting anything. Repeat this procedure for a few times.
If the branches are small in diameter and you want to speed up the cut, set
6.
the opening of the blades at 15 mm instead of 25 mm. For this setting proceed as
follows: after turning on the machine (green LED illuminated), keep the button
pressed
for 2 seconds, until an acoustic signal is emitted. To restore the setting
previous, repeat the operation.

Packing Up

1. Press the trigger, hold for a few seconds and then release; the blades will close
and will not open.
2. Switch o the battery; disconnect the battery.
3. Tidy up, clean and pack the pruner into the tool box.
4. Keep machine out of reach of children.
to open the blades.
19