Descargar Imprimir esta página

Temperature Adjustment - Nitecore AC10 Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12

Temperature Adjustment

Short press "+" Temperature Button / "-" Temperature Button to control the temperature from
16°C to 30℃. If there is no operation in adjustment, the product will automatically exit the
setting status after the real-time display flashes for 5 seconds.
Wind Speed Adjustment
Short press the Wind Speed Button to cycle through the following levels: LOW – MID - HIGH.
Mode Selection
Long press the Sleep Mode Button for 3 seconds to switch between the Cooling Mode and
Sleep Mode.
The Snowflake Icon will be turned on if the product accesses the Cooling Mode. This mode
is ideal for daily use.
The Snowflake Icon will be turned off if the product accesses the Sleep Mode. Once the
Sleep Mode is on, only the built-in fan runs continuously with minimal noise, suitable for
sleeping.
When the product is reactivated, it will automatically access its previous mode
Maintenance
Cleaning Guidance:
Please wipe the exterior of the product with a moistened cloth. If the dirt cannot be wiped
up, clean it with a mild detergent followed by wiping again with a clean cloth.
The air filters of the Evaporator Inlet and Condenser Air Inlet are detachable. Rinse them
with water and reinstall them after fully dry.
Plastic Parts Maintenance:
Please operate the product properly to avoid the oil stain and deforming. DO NOT expose
the product to the sun and it is recommended to use it in the shade.
DO NOT directly rinse the product with water to avoid degradation of the electrical insulation
performance of the internal circuit and rust of the internal parts. The following items are
prohibited to clean the product, avoiding damage to the coating and plastic parts: hot water,
brush, gasoline, alcohol and soap.
Warnings
1. The product is only to be used by adults above 18 years old. Children under this age must
be supervised by an adult when using the product.
2. Please place the product in ventilated areas. DO NOT use the product in a moist
environment.
3. DO NOT touch the plug or other parts with wet hands.
4. DO NOT operate the product if the power cord or plug is damaged.
5. DO NOT operate the product that has been hit, damaged, placed outside for a long time or
dropped into the water.
6. DO NOT expose the product to open flames or extremely high ambient temperatures.
4

Publicidad

loading