Publicidad
e
If your dog barks and the bark collar doesn't seem to be responding:
Recheck the fit.
The bark sensor uses both sound and vibration to detect your dog's bark. This is what prevents
the bark collar from responding to other dogs' barking or loud noises nearby. If the bark collar is too loose, the
bark sensor will not be able to detect the vibration of your dog's vocal cords and the bark collar will not issue
a stimulation.
Test the bark collar.
complete the following steps to test the bark collar. It is best to test the bark collar out of earshot of your dog, to
avoid temporarily acclimating him to the audible stimulation.
Important: Due to the volume of the sound emitted (approximately 92 dBC at 10 cm), always hold the bark
collar at arm's length when testing. The collar is safe when worn by your dog as directed, but like any loud
sound, it should not be played right next to your ear.
1. With the bark collar connected to the charger and to power, press and hold the power button.
2. Continue to hold the power button while unplugging the bark collar from the charger.
3. When the LED turns blue, release the power button. After a 2-second delay, you will hear the bark collar
sound 10 times, once for each level of stimulation. This indicates the bark collar is working correctly.
When the test is complete, the bark collar will beep high to low and turn itself off.
4. You can stop the test at any time by pressing the power button.
Remember these important tips when using your bark collar:
Be consistent.
Use the bark collar in every situation in which you want your dog to be quiet. If your dog realises
he is not wearing his bark collar, he may resume his bad barking habits and his learning will be delayed.
Attach your leash separately.
Please don't attach a leash to the bark collar, as this puts too much pressure on the bark sensor.
Maximise battery life.
the bark collar beeps high to low and the LED flashes red and then turns off. To avoid overcharging the bark
collar and shortening its battery life, only charge the bark collar when the LED flashes red, indicating the battery
charge is low.
20
If you are sure you have fitted the bark collar properly, but it is still not responding,
When using a leash, attach it to a separate, non-metallic collar or harness.
Turn off the bark collar when not in use by pressing and holding the power button until
Publicidad
