Cleaning The Drain Pump Filter - Teka WMK 81050 DSS Manual De Instrucciones

MAINTENANCE

Cleaning the Drain Pump Filter

Warning!
• Make sure that the machine has finished the washing cycle and is empty. Switch it off
and unplug it before cleaning the drain pump filter.
• Be careful of hot water. Allow the water to cool down. Risk of scalding!
• Clean the filter periodically every 3 months to ensure the normal operation of the
appliance.
Open the lower cover cap
Open the filter by turning
to the counter clockwise
Caution!
• Make sure that valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligning to hole plates otherwise water may leak.
• Some machines don't have emergency drain hose, so step 2 and step 3 can be skipped.
Rotate lower cover cap directly to make water run into basin.
• When the appliance is in use and depending on the programme selected there can
be hot water in the pump. Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is empty. When replacing the
cover, ensure it is securely re-tightened.
1
Rotate 90°C and pull out
the emergency drain hose,
and take off the hose cap
4
Remove extraneous matter
2
Emergency
drain hose
5
29
After water runs out,reset
the drain hose
Close the lower cover cap
3
6