Changing Units; Warning Indicators - Orbegozo PC 1020 Manual De Instrucciones

PC 1020 – PC 1021 – PC 1022

CHANGING UNITS

This scale lets you to change the measurements units. Press the button to
choose one unit: gr/Kg/Lb/Oz.
WEIGHT FUNCTION
1. Place the scale in a hard and plane surface.
2. Put a container (in case of use it) in the scale before turning it on.
3. Press soft but firmly the ON-OFF-TARE button to turn it on.
4. Wait a few seconds until all the information is showed.
5. Put in the food in the container and the weight will be showed.
TARE FUNCTION
To weigh different loads consecutively without removing loads from the scale, put the
first load on the scale and get the weight reading. Then press the TARE button to reset
the LCD reading to "0" before adding next load. You can repeat this operation all the
times you need up to the maximum weight capacity of the scale.
NOTE: once pushed the TARE button if you take away weight from the scale, the sign "-"
will be showed. If this weight is more than 750 gr, the symbol no.4 will appear.
AUTO SHUT OFF
Auto shut-off occurs if display shows '0' or shows the same weight reading for 2
minutes.

WARNING INDICATORS

1."LO" = Replace new battery.
2. "EEEEE" = Scale overload. Remove item to avoid damage.
CLEANING AND CARE
1. Clean the scale with a slightly damp cloth. DO NOT immerse the scale in water or use
chemical / abrasive cleaning agents.
2. Always use the scale on a hard, flat surface. DO NOT use on carpet.
3. DO NOT strike, shake or drop the scale.
4. The scale is high precision device. Please take care of it.
5. Please keep it dry.
6. Please check whether battery is installed or in high level if scale cannot be turned on.
7. Do not mix batteries with other household wastes.
8