B-tec 808B-12 Instrucciones De Uso página 4

EN
USING THE TOOL
1. Ensure that the switch is off 4 before connecting the
battery 1
2. Load the tool by inserting an adhesive stick into the
rear 2
3. Operate the trigger to feed the stick forward until
resistance is felt 3
4. Switch on tool in HOTMELT 5 or ECO 6 mode and
wait 3 minutes to warm
5. Operate the trigger to extrude adhesive until the stick
has been completely drawn into the rear of the tool
6. Insert a new stick into the tool 2
7. Switch off the tool when work is complete 4