ProBreeze PB-15 Manual De Instrucciones página 8

• Turbo: press once to start Turbo Mode. This will increase the fan speed to maximum.
Press again to reduce the fan speed.
• Timer: this button controls the auto-start and auto-stop functions.
• For auto-start, turn the unit off using the power button. Press the timer button until
the "on" light illuminates. Use the arrows to select the auto time (available in 30
minute increments, up to 24 hours). Once selected, wait five seconds. The LED
display will return to blank. The unit will turn on after the time has been reached.
• For auto-stop, turn the unit on using the power button. Press the timer button until
the "on" light illuminates. Use the arrows to select the auto time (available in 30
minute increments, up to 24 hours). Once selected, wait five seconds. The LED
display will return to showing the RH. The unit will turn off after the time has been
reached.
• Turning the unit on or off, or reducing the time to 0 will turn off timer mode. The
unit will turn off after the time has been reached.
• Up / Down Buttons: press to control the humidity level. The humidity level can be set
from 25% RH to 85% RH in 5% increments. For drier air, set a lower RH. For damper air,
set a higher RH.
Lights
• Auto, filter, continuous lights: these will illuminate when the modes are activated.
• Defrost: this will illuminate when frost builds up on the evaporator coils. When this
happens, the compressor will turn off and the fan will continue to run until the coils
defrost.
• Full: this will illuminate when the water tank is full and needs to be emptied. To empty,
follow the instructions listed below.
Display
• As a default, the LED display will show the RH (relative humidity) of the room to +/- 5%
accuracy.
• If there is a problem with the unit, the following will display:
• P2: water tank is full or not in the right position. Empty the water tank or check its
positioning.
• AP: device is in auto-pairing mode, which is used to connect to wifi. This mode
should turn off automatically within 8 minutes.
• AS: humidity sensor error. Unplug the unit, wait 30 seconds and plug back in. If
the problem persists, contact support.
• ES: tube temperature sensor error. Unplug the unit, wait 30 seconds and plug
back in. If the problem persists, contact support.
7 | English