Descargar Imprimir esta página

Line Feed On Autocut Mowing Heads; After Finishing Work; Transporting; Transporting The Brushcutter - Stihl FSA 86 R Manual De Instrucciones

Ocultar thumbs Ver también para FSA 86 R:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
English
► Swing the brushcutter steadily back and forth
in an arc.
► Move forward slowly in a controlled manner.
► If you work with a bump guard (1): Extend the
bump guard (1) fully.
13.3
Line Feed on AutoCut Mowing
Heads
► Briefly tap the rotating mowing head on the
ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector auto‐
matically cuts the mowing lines to the correct
length.
2
1
Automatic feed will not take place if the mowing
lines are shorter than 25 mm.
► Switch off the brushcutter and remove the bat‐
tery.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2) by hand.
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.

14 After Finishing Work

14.1
After Finishing Work
► Switch off the trimmer and remove the battery.
► If the trimmer is wet: Allow the trimmer to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.
30

15 Transporting

15.1
► Switch off the brushcutter and remove the bat‐
tery.
1
Carrying the Brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.
15.2
► Switch off the brushcutter and remove the bat‐
tery.
► Check that the battery is in a safe condition.
► Pack the battery in packaging in such a way
that it cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
as UN 3480 (lithium ion batteries) and has been
tested pursuant to UN Manual Tests and Criteria
Part III, Subsection 38.3.
The transport regulations can be found at
www.stihl.com/safety-data-sheets.

16 Storing

16.1
► Switch off the trimmer and remove the battery.
► Remove the spool.
► Observe the following points when storing the
trimmer:
– The trimmer is out of the reach of children.
– The trimmer is clean and dry.
16.2
STIHL recommends keeping the battery in a
charging state between 40% and 60 % (2 green
LEDs lit).
14 After Finishing Work

Transporting the brushcutter

Transporting the Battery

Storing the Trimmer

Storing the Battery

0458-833-9821-C

Publicidad

loading