Dust/Chip Extraction; Operating Modes - IKEA FIXA Serie Manual De Instrucciones

holder. Tighten the two socket head screws
(13) using the Allen key (11).

Dust/Chip Extraction

Dusts from materials such as lead-
containing coatings, some wood types,
minerals and metal can be harmful to
one's health. Touch ing or breathing-in the
dusts can cause aller gic reactions and/
or lead to respiratory infec tions of the
user or bystanders. Certain dusts, such
as oak or beech dust, are considered as
carcinogenic, especially in connection
with wood-treatment additives (chromate,
wood preservative). Materials containing
asbestos may only be worked by
specialists. Use dust extraction whenever
possible. Provide for good ventilation of
the work ing place. It is recommended to
wear a P2 filter-class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Connecting the Dust Extraction
Insert the dust extraction adapter (9) into
the dust extraction connection (8). Align
the 2 pins of the dust extraction adapter
with the holes in the dust exhaust of the
machine. Twist the dust extraction adapter
a quarter turn counter clockwise to lock it
into place.
Connect the hose of a vacuum cleaner to
the dust extraction adapter (9).
To remove the dust extraction adapter (9),
twist the dust extraction adapter a quarter
turn clockwise. Pull the dust extraction
adapter from the machine.
The vacuum cleaner must be suitable
for the ma terial being worked. When
vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a
special vacuum cleaner.
All manuals and user guides at all-guides.com

OPERATING MODES

Before any work on the machine itself,
pull the mains plug.
injury, never use the tool when the base
plate (4) is loose or removed.
Adjusting the Cutting Angle
(see figure B).
•
•
•
•
•
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine.
WARNING! To reduce the risk of
The base plate (4) can be swivelled by
45° to the left or right for mitre cuts.
Insert a saw blade (6).
Loosen the two socket head screws
(14) and lightly slide the base plate (4)
toward the vacuum connection (8). For
adjustment of precise mitre angles, the
base plate has adjustment notches on
the left and right at 0°, 15, 30 and 45°.
Swivel the base plate (4) to the desired
position according to the scale (3).
Afterwards, push the base plate (4)
to the stop in the direction of the saw
blade (6). Other mitre angles can be
adjusted using a protractor but then the
adjustment notches do not work.
Position the holder for the guide roller
(7) in such a manner that the guide
roller (5) faces against the back of the
saw blade. Precise cuts are possible only
when the guide roller faces closely but
not to tightly against the back of the saw
blade.
Tighten the two socket head screws (14)
again.
9