KitchenAid KSMSIA Manual página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TIPS FOR GREAT RESULTS
Preparing Your Ice Molds
• It is important to note the subtle fill
line just below the top rim of the Ice
Molds. Please do not fill the molds
beyond this line as it may negatively
affect freezing.
• Allow ice molds to freeze for a
minimum of 12 hours. Note that some
mixed base recipes may require more
time to freeze due to a variety of
ingredients.
• For recipes with sugar, there is a
delicate balance between a mixture that
is sweet to the taste but still capable of
freezing hard enough to shave. Please
follow recipes as closely as possible to
ensure great results.
• For recipes with Alcohol, you should
not exceed an above over 8% within the
mixture. This will help ensure the mixture
freezes hard enough to shave.
• Consider removing frozen ice pucks
from the molds and storing them in
another container inside your freezer.
This is referred to as "Ice Harvesting"
and will help ensure you always have
ice on hand when the occasion calls for
Shave Ice.
FOR DETAILED INFORMATION ON USING THE SHAVE ICE ATTACHMENT
Visit
www.kitchenaid.com
how to use your Shave Ice Attachment.
W11499125A.indb 11
W11499125A.indb 11
Shave Ice Troubleshooting Tips
• Fine Blade Creates Coarse Ice - This
can occur if the ice is still too cold.
Consider extending the tempering time.
Alternatively, check the blade for any
possible damage as this can affect shave
performance.
• Puck Does Not Shave - This can occur
when a recipe mixture is too soft or too
hard. If the mixture is too soft, it may
contain too much sugar or alcohol to
freeze properly. Consider revisiting the
recipe. If the mixture is too hard, the
puck may need to temper for longer. See
"Making Shave Ice".
• If issues persist, please contact
KitchenAid customer service. Visit www.
KitchenAid.com for contact information
specific to your region.
or additional instructions, videos, inspiring recipes, and tips on
11
10/14/2021 12:55:11 PM
10/14/2021 12:55:11 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido