Disposing Of The Device; Spare Parts List - Sabo ST-30 Manual Del Operador

There is no electrical contact
between the machine and the
battery.
The battery is empty.
The cutting line is stuck.
There is not enough cutting line
on the spool.
The cutting line
The cutting line is worn and too
does not lengthen.
short.
The cutting line is wound around
the spool.
The cutting line
The machine is not used properly.
keeps breaking.
Grass winds
around the shaft High grass is cut too close to the
housing and the ground.
trimmer head.
The cutting line is
The cut-off blade (8) is dull.
not cutting well.
The vibrations are The line is worn down on one side
increasingly and did not advance when it was
significantly. supposed to.

13 DISPOSING OF THE DEVICE

Do not dispose of electric devices with household waste. Dispose of these devices at recycling centres.
Contact the relevant authorities or your retailer for information about this.
Separate collection of used products and packaging allows materials to be recycled.
The reuse of materials helps to prevent pollution and reduces the demand for raw materials.
Dispose of batteries at the end of their service life and in a manner that respects the environment.
The battery contains material that is dangerous to you and to the environment.
Therefore, it must be disposed of separately in a facility that accepts lithium-ion batteries.

14 SPARE PARTS LIST

Please contact the dealer. They can provide you with a list of the spare parts.
·
Remove the battery.
·
Check the contact.
·
Re-insert the battery.
Charge the battery.
Oil with silicon spray.
Install a new spool. For this, see the section in these instructions about replacing the cutting line.
·
Remove the battery.
·
Pull the line while pushing the trimmer head.
Remove the cutting line from the spool and wind it up. For this, see the section in these instructions about replacing the
cutting line.
·
Cut with the tip of the cutting line and avoid contact with rocks, walls and other hard objects.
·
Advance the cutting line regularly for full cutting breadth.
·
Cut high grass from top to bottom.
·
Do not cut more than 20 cm in each pass to prevent grass wrapping around.
·
Sharpen the cut-off blade (8) with a file or replace it.
Make sure that the cutting line can move freely on both sides. Move the cutting line to check.
36