Jocel JMFG001764 Manual De Instrucciones página 24

Step 9: If is on, if still want to make ice, then add water to the water tank ,same as step
2.If no water is pumped up to the water tray over two cycles but the water in water tank is
enough, then please open the drain cap, and let several drops water runs out.
Noted: please take out the ice first, then add one full cup of water, so as to avoid overflow of
water when the ice melt.
Step 10: Also you can set the clock, automatically turn on and turn off time via following steps:
1. Set clock: press "TIME" and "SET" alternatively to change the time, three seconds later the
setting is valid.
2. Turn On: press button "TIME" till the indicator ON beside the time area lights up, then press
"TIME" and "SET" alternatively to change the time, after the time flash stops, press "SET"
again till the indicator ON beside the time area is always lights up.
3. Turn off: button "TIME" till the indicator OFF beside the time area lights up, then press "TIME"
and "SET" alternatively to change the time, after the time flash stops, press "SET" again till the
indicator OFF beside the time area is always lights up.
Step 11: When
tray.
Notice: For best performance, water temperature should be between 7°C and 35°C and ambient
between 15°C and 38°C.
CARING
1. Clean the inner liner, ice collecting tray, water tank, ice shovel and evaporator frequently.
When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and
vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker
with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before
starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of
obstruction. Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
3. If the icemaker is reused after a long time, the water pump may not pump sufficient water due
to an air block; the deficient water indicator turns on in this case. To correct this press the
START button again, then the icemaker will work normally.
4. To ensure the cleanliness of the ice cubes, water in the water tank should be replaced every
24 hours.
5. If the compressor stops for any reason such as water shortage, too much Ice, power off, etc...
Do not start the system right away, wait 3 minutes, and then re-start the Ice maker.
6. Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
is on, please pull the drawer out, and take out the ice with the ice collecting
24