Unpacking; Disposal Of The Packaging; Setup Location Requirements - CASO DESIGN IceChef Pro Manual Del Usuario

13.5 Unpacking

Unpack your ice maker as follows:
 Take out the ice maker from the box and remove the interior and exterior packaging.
 Remove the tapes for fixing the ice scoop and ice basket.
 Before using your ice maker for the first time, thoroughly clean the water reservoir and
the ice basket as well as the ice shovel (see chapter Cleaning and Maintenance).
 Clean the interior of the machine with water. Open the drain cap on the front bottom
side to drain out the water from the ice maker.

13.6 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

13.7 Setup location requirements:

 In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity.
 Do not leave the ice maker to direct sunlight.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 10 cm on all sides.
 WARNING! Do not close the ventilation openings in the device housing.
 Do not remove the device's adjustable feet.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
Please note
32