Satco NUVO 65-754 Manual De Instalación página 2

INSTALLATION: Wall Mount
STEP 1: Turn power OFF. Use a screwdriver
to remove the screws on both sides.
STEP 2: Open the fixture, disconnect the
connection terminals, and remove the upper
cover of the fixture.
STEP 3: Drill through the mounting hole with an
electric drill.
STEP 4: Drill a hole in the wall with an electric drill.
STEP 5: Push the expansion rubber plug into
the mounting hole on the wall.
STEP 6: Use a screwdriver to remove the side
plug and attach the EVA cotton pad to the
mounting hole.
STEP 7: Push the expansion rubber plug into the
mounting hole on the wall.
STEP 8: Connect the wire tube through the side
hole. Connect the wires, refer to wiring diagram.
(L = Black, N = White, G = Yellow/Green).
STEP 9: Install the cover of the fixture and
connect the terminal block.
STEP 10: Secure fixture with screws. Installation
is complete. Turn power ON.
Wattage Selectable Instructions
• Turn the wattage Selectable knob to a certain wattage gear, the power of the lamp
will change to the corresponding wattage.
NOTE: Turn OFF the power before adjusting the wattage. Factory default setting is set
to the highest output.
Photocell and CCT Adjustment Integrated Controller
• The color temperature of the lamp turns to 3000K when the DIP switch is set to 3K
• The color temperature of the lamp turns to 4000K when the DIP switch is set to 4K
• The color temperature of the lamp turns to 5000K when the DIP switch is set to 5K
Photocell Function
• Turn the DIP switch to ON means the photocell is turned ON
• Turn the DIP switch to OFF means the photocell is turned OFF
NOTE: Turn OFF the power before adjustment. Factory default setting for photocell
is ON and 4000K for CCT.
WIRING DIAGRAM
L
N
G
© Copyright 2021 Satco Products, Inc. 12/21 v1.1
1
4
7
Battery
-
BATTERY
L(Black)
+
(Red)
+
DRIVER
N(White)
(Black)
DRIVER –
NC
(White)
LED –
+ (Grey)
PG(Green) LED
EM Driver
EM Switch
Photosensitive
(Black)
L(Black)
Resistance
V-(Black)
N(White)
V+(Red)
Dim+(Purple)
G(Green)
Dim-(Pink)
LED Driver
2
2
5
8 9
CCT
(White)(Grey)(Grey)(White)(Blue)
Dim+(Purple)
+
Dim-(Pink)
–
Power Switch
3
6
10
V+(Grey)
VH-(Blue)
VL-(White)
Satco Products, Inc.
Brentwood, NY 11717