Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
PIECE INVENTORy
NOTICE
A full parts list and breakdown can be found toward the end of
this manual. For easier assembly, or to identify missing parts,
please refer to the detailed illustrations at the end of the manual.
After all the parts have been removed from the carton, you
should have:
Fig. 3. Parts inventory 1
BEgINNINg ASSEMBLy
Disconnect power from the machine
when performing any maintenance,
assembly or adjustments.
Failure to do this may result
in serious personal injury.
Wear safety glasses during the entire
assembly process.
Failure to comply may result
in serious personal injury.
W A R N I N G
W A R N I N G
Box 1:
Extension Wing ..................................................................... 1
Box 2:
• Miter gauge ....................................................................... 1
• Handle for handwheel ........................................................ 1
• Spindle1-1/2"....................................................................
• Splinde 1-3/4" ..................................................................
• Router bit 1/2" .................................................................. 1
• Router bit 1/4" .................................................................. 1
• Safety guard ...................................................................... 1
• Safety guard shaft ............................................................. 1
• Hold downs ........................................................................ 4
• Hold down bars .................................................................
• Hold down brackets ........................................................... 4
• Extension bracket w/lock knob ......................................... 1
• Lock handle ....................................................................... 1
• Guard extension bar .......................................................... 1
• Shaft mount bracket w/set screw ..................................... 1
• Fence lock handle .............................................................. 2
• Rear door panel knob ........................................................ 1
Fig. 4 Parts inventory 2
Most of your 3HP heavy duty Shaper has been assembled at
the factory, but some parts must be assembled or installed
after delivery. We have organized the assembly process
into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a 12" to 18" long
straightedge, 12, 14, and 17mm open end wrenches,
4 and 8mm hex wrenches, and a Phillips and flat
head screwdriver.
2
C A U T I O N
Some metal parts may have sharp
edges on them after they are formed.
Please examine the edges of all
metal parts before handling them.
Failure to do so could result in injury.
Qty
1
1
2
Publicidad
