Publicidad
Idiomas disponibles
Idiomas disponibles
SEP UP
SPINDLE
This 3HP shaper comes with1 3 1⁄2", ⁄4", & 1" interchangeable
spindles. Each spindle is sized to work efficiently with different
sized cutters and spacers. The spindles must be inserted
correctly and remain securely locked in the machine in order
to produce quality work. When installing and changing spindles,
make sure the spindle seats snugly and that there is enough
drawbar threaded into the bottom of the spindle to safely secure
it in place.
W A R N I N G
Incorrect assembly can allow the spindle and cutter to
fly off the machine, which could cause injury or death.
Make certain the spindle is properly assembled before
operating the Shaper. If you are uncertain of any aspect
of this assembly, please review these instructions again
or contact our Customer Service.
To install a spindle:
1. KEEP SHAPER DISCONNECTED FROM POWER!
2. Remove the hex nuts from the spindle and the drawbar nut
from the drawbar.
3. Thread the drawbar approximately 10-15 turns into
the bottom of the spindle. The drawbar has two threaded
ends. One of them remains exposed. See Figure 5.
10-15 Turns
Fig. 5 Spindle and drawbar.
4. Place the spindle/drawbar
into the spindle cartridge
at the top of the table.
Line up the keyway on the
spindle with the locating pin
at the top of the spindle
cartridge.
You will feel the spindle seat
itself. See Figure 6.
Fig. 6 Inserting the spindle into place.
Spindle
Drawbar
Spindle
cartridge
C A U T I O N
Make sure the spindle keyway and pin are aligned
and properly seated before tightening the drawbar
nut. Improper assembly can create an unsafe
condition and possible injury to the operator.
5. Thread the drawbar nut, tapered
side up, onto the bottom of the
drawbar until it stops below
the spindle housing cartridge.
See Figure 7.
6. Place the spindle wrench on top of the spindle, so it fits
over the head of the spindle. Place a 17mm wrench on the
drawbar nut. See Figure 8.
7. Hold the spindle in place and tighten the drawbar nut.
DO NOT use excessive force.
3
Fig. 7 Nut threaded onto drawbar.
Fig. 8 Tightening the drawbar nut.
Publicidad
