Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
MT250PC_PCW 825-0051.qxd:MT250PC_PCW I.S. 325-1321.qxd
Mounting your fixture
Step 1: Turn off the power at the main fuse/breaker box.
Step 2: Line up the holes on the mounting bracket (I) with the holes on
your junction box. Using either (2) #6 screws or (2) #8 screws
(depending on size of the holes in your junction box), attach the
mounting bracket to your junction box.
Step 3: Thread fixture wires though coverplate gasket (C).
Step 4: Connect fixture black wire to house black wire, fixture white wire to
house white wire, and copper colored ground wires, (coming from
the fixture coverplate and fixture) to house ground wire using wire
nuts provided (F).
Step 5: Attach fixture (B) to the mounting bracket using the center bolt
provided (H). Insert plastic center hole plug (G) in center hole for
finished appearance.
Step 6: Apply silicone caulking around edges of coverplate and in any
open holes to provide a watertight seal from rain and moisture.
Step 7: Insert gaskets (D) into lampholders and screw bulbs (A) into each
lampholder (do not over-tighten bulbs)
Step 8: Turn power on at main fuse/breaker box.
Aiming the light
Aiming the light
Loosen the knob on the side of the light housing. Tilt fixture head up or down
to desired position then retighten knob. WARNING: Deviation from the assem-
bly instructions may result in a risk of fire or electric shock.
SAVE THESE INSTRUCTIONS.
What to do if...
LIGHT DOES
NOT COME ON
LIGHT COMES ON FOR
ONLY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT COMES ON
RANDOMLY
Is there power to the fixture?
• Has the house circuit breaker tripped?
• Is the wall switch ON?
Is the bulb(s) plugged or screwed in completely?
• Is the bulb(s) good? (Be careful not to overtighten.)
Is the light sensor able to determine darkness?
• Cover light sensor with electrician's tape. Wait 2-3
min. to see if light turns on. If it does, the sensor is
receiving too much light.
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
Is the light sensor sensing reflected light?
• Cover light sensor with electrician's tape. Wait 2-3
min. to see if light turns on. If it does, fixture is receiv-
ing reflected light. Partially cover the light sensor to
block out the reflected light.
Is the light sensor in a shaded area?
• Shine a flashlight into the light sensor for 2-3 min. If
the light turns off, the fixture is mounted in an area that
does not allow enough light to enter the light sensor.
Is the light sensor good?
• Shine a flashlight into the light sensor for 2-3
min. If the light does not turn off, the light sensor is
bad. Contact customer service.
3
1/25/08
10:49 AM
Page 3
Publicidad
