Setting The Stroke Rate; Changing The Engraving Point - Parkside PGG 15 A1 Instrucciones De Utilización Y De Seguridad

Operation
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
©

Setting the stroke rate

The stroke switch
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
increase the penetration depth.
Turn the switch for the number of strokes
decrease the penetration depth.
©

Changing the engraving point

WARNING!
performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point is released.
5
Insert a new engraving point
holder clockwise to lock the engraving point in position.
6
Ensure that the engraving point
62 GB/MT
All manuals and user guides at all-guides.com
.
1
1
is used to set the penetration depth of the engrav-
2
RISK OF INJURY! Switch the device off before
5
anticlockwise until the engraving
6
5
.
in the + direction to
2
in the – direction to
2
as soon as it becomes too worn
and turn the engraving point
is properly fixed in position.
5