WATER FILTRATION PREPARATION
•
Unlock the locking latches pulling outwards as shown in the figure.
•
Put the motor bonnet away by pulling the carrying handle.
•
Put the water filter exhaust inside the tank by pushing it to the suction mouth.
•
Fill the tank with water.
Note: The amount of water should not be less than the „MIN" level on the tank and
not more than the "MAX" level.
•
Put the motor bonnet back on the tank and lock the latches by pushing right and
left.
•
Connect the hose by inserting it into the suction mouth.
•
After connecting the tubes to the hose handle, attach the desired accessory.
•
You can use your machine without tubes by connecting the accessory directly to
the hose handle.
•
Plug the cord into the power socket.
Warnings :
•
The shampoo switch should be off while dry vacuuming.
•
Never use your machine without water when using the water filtration function.
•
Detergent residues from carpet and parquets cleaning causes foaming in the tank.
In that case immediately switch off the unit and change the water in the tank,
otherwise your motor will be damaged by foam. If the foaming water does not have
to be changed, you can use the foam reducer.
TKG SVC 1000
10