Publicidad
Idiomas disponibles
Idiomas disponibles
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
SPECIFIC SAFETY INSTRUCTIONS
• Check your powertool for damage before star-
ting your work, particularly the diamond blade.
All parts must be fitted properly and must meet
all requirements in order to guarantee the
tool's smooth operation. Any safety guards or
any lightly damaged parts must be checked to
see if they still function properly before con-
tinuing the use of the tool. Moving parts, and
the diamond-blade guard in particular, must be
fitted properly and must not jam. Do not use
tools that cannot be switched on or off with the
switch.
• The diamond-blade guard must not be jammed
or removed.
• A jamming guard must be repaired immediately.
• The riving knife must not be removed.
• The diamond blade must NEVER be exposed
to sideways pressure; they can break and the
flying pieces become projectiles!
• Do not attempt to cut extremely small pieces
from the tiles. Always make sure that the full
surface of the tile is on the work table. The sup-
plied mitre guide can be used to push the tiles
through the cutter. In the early stages of cutting
in particular, the tile must remain absolutely
level to avoid the tile moving up.
• Do not overload your tool. It is better and safer
to work within the indicated power range. Do
not cut materials other than tiles.
• Maintain your tools carefully. Keep the tools sharp
and clean in order to work properly and safely.
• Follow the maintenance instructions and the
instructions for replacing the diamond blade.
• Stand safely and maintain your balance. Avoid
any unnatural body angles. Remain alert and
pay attention to your work. Use common sense.
Do not use the machine when you cannot con-
centrate or when you are tired.
• Cracked or distorted diamond blades must be
replaced.
• Type of disk: a diamond blade with a diameter
of 180mm.
WWW.VONROC.COM
• Do not use diamond blades that do not meet
the specifications in these instructions.
• Ensure that the diamond blade is secured
properly and rotates in the correct direction.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Connecting to the power supply
Check that the power supply and plug used in
accordance with tour tool. Have a look at the rating
plate on the tile cutter. Any changes should always
be carried out by a qualified electrician.
Warning! This machine must be earthed.
If not properly earthed this machine can cause an
electrical shock. Be sure that the power supply out-
let is earthed. If there is any doubt, have it checked
by a qualified electrician.
Warning! Avoid contact with the terminals
on the plug when installing (removing) the
plug to (from) the power supply outlet.
Contact will cause a severe electrical shock.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is dangerous
to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
always unwind the reel completely.
2. MACHINE INFORMATION
Intended use
This tool is suitable for cutting various wall and
floor tiles. It is not permitted to use the tool for any
other materials.
. When using a cable reel
7
EN
Publicidad
