Technical Specifications - VONROC TC501AC Traducción Del Manual Original

EN

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power consumption
IP Class
No load speed
Max. depth of cut 90º
Max. depth of cut 45º
Cutting angle
Ø Cutting blade
Table dimensions
Lpa (sound pressure level)
Lwa (sound power level)
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
- Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
- The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. On/Off switch
2. Parallel guide scale
3. Bevel table
4. Transport handle
5. Bevel table handle
6. Table drain
7. Cutting wheel
8. Riving knife
8
9. Guard knob
10. Guard
TC501AC
11. Miter guide knob
230V~
12. Miter guide
13. Parallel guide
50 Hz
14. Parallel guide knob
650W S2 30 min
15. Hex wrench
IPX4
16. Spindle wrench
17. Wheel nut
6500/min
18. Spindle
46 mm
19. Lower blade guard
30 mm
20. Inner wheel flange
21. Outer wheel flange
0 - 45°
22. Overflow drain
Ø180 x Ø22.2 x 2.2 mm
23. Max water fill line
345×345mm
24. Water reservoir
94+3 dB(A)
3. ASSEMBLY
107+3 dB(A)
Mounting the cutting wheel (Fig. A, B & C)
1. Pull the bevel table handle (5) and remove the
2. Loosen the screw holding the lower blade guard
3. Remove the lower blade guard (19).
4 Put the hex wrench(15) on the wheel nut (17)
5 Remove the nut (17) and the outside flange
6. Mount the cutting wheel (7).
7. Mount the outside flange (21) and afterwards
8. Tighten the nut by using the wrenches.
9. Now re-mount the lower blade guard (19) and
First remove the plug from the mains before
the cutting wheel is assembled or replaced.
Cracked or distorted diamond blades must
be replaced.
Do not use diamond blades that do not meet
the specifications in these instructions.
Ensure that the diamond blade is secured
properly and rotates in the correct
direction.
bevel table (3).
(19), as shown on figure C.
and the spindle wrench (16) on the spindle
(18). Loosen the nut with the wrenches, as
shown on figure B.
(21) from the spindle (18).
add the wheel nut (17).
fixate it by tightening the screw.
WWW.VONROC.COM