Descargar Imprimir esta página

Start-Up; Charging The Rechargeable Battery; Fitting And Removing The Recharge- Able Battery (04); Operation - AL-KO TL 1820 Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 59
GB
Disconnecting motor head and basic
appliance
1. Turn the locking sleeve in the direction of
the open padlock.
2. Pull upper and lower handle tube apart.

5 START-UP

5.1

Charging the rechargeable battery

Observe the temperature range for charging, see
technical data.
NOTE For detailed information, see the sep-
arate operating instructions for the rechargeable
battery and the charger:
Operating manual 443130: Rechargeable
batteries
Operating manual 443131: Chargers
5.2
Fitting and removing the rechargeable
battery (04)
IMPORTANT! Danger of damage to the re-
chargeable battery. If the rechargeable battery
is left in the appliance after use, it may damage
the rechargeable battery.
Immediately after use, pull the rechargeable
battery out of the appliance and store in a
frost-protected area.
Only insert the rechargeable battery in the
appliance immediately before starting work.
Installing the battery
1. Push battery (04/1) into the upper handle
from below (04/a) until it engages.
Removing the battery
1. Press and hold the unlock button (04/2) on
the rechargeable battery.
2. Pulling out the rechargeable battery (04/b).

6 OPERATION

WARNING! Risk of injury due to detach-
ing appliance parts. Appliance parts detaching
during operation can lead to serious injury.
Before turning the appliance on, check that
all the parts of the appliance are firmly tight-
ened.
Attach cutting tools so that they cannot de-
tach during operation.
28
6.1
Checking the charge status of the
rechargeable battery
Charge status indicator (01/3) is located on the
top of the basic tool.
It has three segments. The segments light up or
flash, depending on the battery charge status.
Segment
3 segments lit:
2 segments lit:
1 segment lit:
1 segment flashing:
6.2
Switching the appliance ON and OFF (05
- 07)
1. Stand securely.
2. Hold the upper handle (05/1) with one hand
and the loop handle (05/2) with the other
hand.
3. Hold the motor head (06/1) slightly above the
soil to be cultivated. The cultivator blades
(06/2) should not touch the ground.
4. Press unlocking button (07/1) in the upper
handle.
5. Press and hold the ON/OFF switch (07/2) in
the upper handle. The appliance starts. The
unlocking button can be released.
6. Press the rotating cultivator blades into the
soil with the loop handle. If you notice that
the cultivator blades are blocked by the soi,
raise the tool slightly.
7. To switch off the appliance: Release the ON/
OFF switch.
WARNING! Danger of cuts and lacera-
tions. After the appliance has been switched off,
the cultivator blades continue to rotate for a few
seconds. Reaching into the blades during this
time can result in cutting injuries.
Wait until the cultivator blades have come to
a complete standstill.
Start-up
Battery charge level
Rechargeable battery
fully charged.
Rechargeable battery
2/3 charged.
Rechargeable battery
1/3 charged.
Rechargeable battery
almost flat. The appli-
ance will switch off
shortly.
TL 1820

Publicidad

loading