Descargar Imprimir esta página

AquaMedic EVO 1 Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34
3.1. Smart configuration (WiFi mode):
Click on "Add" in the lower left corner of the APP and select the device type to be added on the following page,
in the case of a dosing pump of the EVO 1, 3, 5 type series the pump symbol "reefdoser".
Configuration mode: Make sure your phone is connected to 2.4 G band WiFi before configuration. It
doesn't work in the 5 G band WiFi.
This is the mode for pump control via WLAN. Press the WiFi button for approx. 5 seconds until the red and green
LEDs on the top of the device flash alternately. The device is in WiFi configuration mode.
When the LEDs are flashing alternately, tap the circle in front of "Device is in smart configuration mode" and
click "NEXT". Follow the instructions. Check whether the network name is correct (if not, the smartphone is on
the wrong network), then enter the correct WiFi password and tap "NEXT". Make sure your pump, phone and
router are as close together as possible during the configuration process.
Fig. 4: The tick must be set behind the device's name before tapping on "NEXT". Now, select the device in the
APP that you want to add, tap on the device's name (a tick appears behind the device's name) and then tap on
"NEXT". AP network: Not available at the moment.
4.
Pump control
Fig. 5: Page "My Devices"
In the APP, on the page "My Devices", tap the device's symbol of the desired pump for two seconds to call up
the device control. If you only briefly tap the symbol, the respective device is switched on (blue symbol) or off
(grey symbol). After successfully adding the pump, press and hold the pump icon for two seconds to enter the
pump control page.
13

Publicidad

loading

Productos relacionados para AquaMedic EVO 1

Este manual también es adecuado para:

Evo 3Evo 5