Preparation Before Cleaning; Cleaning/Disinfection; Product-Specific Safety Instructions For The Reprocessing; Procedure - Aesculap Acculan 4 TPLO Instrucciones De Manejo

7.4

Preparation before cleaning

►
Prior to the first mechanical cleaning/disinfection process, mount the
ECCOS fixations in a suitable tray (e.g. GB243800).
►
Insert the products in the correct position into the ECCOS fixations, see
Fig. C.
7.5

Cleaning/disinfection

7.5.1 Product-specific safety instructions for the reprocessing pro-
cedure
Damage to the product due to inappropriate clean-
ing/disinfecting agents and/or excessive tempera-
tures!
CAUTION
►
Use cleaning and disinfecting agents according
to the manufacturer's instructions which
– are approved for plastic material and high-
grade steel,
– do not attack softeners (e.g. in silicone).
►
Do not use cleaning agents that contain ace-
tone.
►
Observe specifications regarding concentration,
temperature and exposure time.
►
Do not exceed the maximum temperature of
60 °C during chemical cleaning and/or disinfec-
tion.
►
Do not exceed the maximum temperature of
96 °C during thermal disinfection with FD
water.
►
Dry the product for at least 10 minutes at a
maximum of 120 °C.
Damage or destruction of the batteries due to pro-
cessing!
►
CAUTION Protect battery from moisture.
Note
The indicated drying time is a guide time only. It must be checked taking
into account the specific conditions (e.g. load) and if applicable adjusted.
9