ACDelco ARG1213 Manual Información Del Producto página 11

WARNING!! Have you read the "General Safety Rules" and "Specific Safety Rules
and Symbols" of this manual? If not, please do so now before you operate this rotary
tool. Your safety depends on it!
Every time you use the rotary tool, you should verify the following:
1. All accessories being used are in good condition and not damaged in any way.
2. Workpiece is properly secured and the accessory is tight.
3. Safety glasses are being worn.
4. After powering on the tool, keep it running about 1 minute in no-load operation.
Failure to adhere to these safety rules can greatly increase the chance of injury.
POWER ON/OFF
WARNING!! Always check to make sure the bit is tightly installed in the collet and
the cutting accessory is NOT touching anything before turning the power on.
WARNING
NOTE
This tool is lubricated before it leaves the factory. This lubrication
should last for the life of the tool. No further lubrication is required.
1. When servicing, use only identical parts. Use of any other part may create a hazard
or cause product damage.
2. DO NOT use solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use a clean cloth to remove dirt, dust, oil, grease etc.
3. DO NOT at any time allow brake fluids, gasoline, petroleum-based products,
penetrating oils, and etc. to come in contact with plastic parts. They contain
chemicals that can damage, weaken or destroy plastic.
4. DO NOT abuse power tools. Abusive practices can damage the tool as well as the
workpiece.
5. DO NOT attempt to modify this rotary tool or create accessories not recommended
for use. Any such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious injury. It will also void the
warranty.
1English1
OPERATION
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
English -10