Starting The Unit - ulsonix AIRCLEAN 15000-H20 Manual De Instrucciones

CAUTION!

STARTING THE UNIT:

1. Set the unit in the desired location.
2. Plug the power cord [9] into the power receptacle on the back of the unit
[6] and then plug it into an electrical outlet.
3. Set the desired operating mode AIR or WATER [2]. For WATER mode,
connect the tube [3] to the ozone outlet connector and/or pumice diffuser
[4].
4. Set the timer control knob to the desired position, i.e. continuous
operation - HOLD or timer (0-180 minutes). After turning the knob, the
unit starts working, i.e. generates ozone!
5. Leave the room as soon as possible!
6. After the ozone treatment has finished, enter the room, switch the unit
off (set the timer control knob to OFF) and open the windows, ventilation
grilles and the mechanical ventilation in the ozonized room, then leave
again. You can safely return to the room after about 15-30 minutes. Not
ventilating the room is permitted. In this case, you should not enter the
room until at least 2 hours after completing the ozone treatment.
7. Disconnect the unit from the power supply.
CAUTION! After switching on the unit, all people and pets should leave the
room!
CAUTION! In AIR mode the room to be ozonized should be sealed, i.e.
doors and windows closed, mechanical ventilation closed or ventilation grilles
covered.
Place a sign in front of the door(s) of the room being ozonized:
DEODORIZATION IN
PROGRESS
(OZONING)
ENTRY FORBIDDEN