Bosch GSR12V-300 Instrucciones De Funcionamiento Y Seguridad página 10

2610051568.qxp_GSR12V-300 12/19/18 1:15 PM Page 10
The belt clip can be positioned on either
side of the tool and secured to the back of
the tool with a mounting screw (Fig. 6).
Always make sure you securely tighten the
mounting screw before use.
To use clip, turn tool upside down and
attach to your belt.
▼ 4X BIT TIP HOLDER
on-tool bit tip holder. Longer bits could
interfere with proper tool operation and
result in user injury.
The four piece bit tip holder can be used
for convenient on tool storage of your most
commonly used bits. The bit tip holder can
be used on its own, or in conjunction with
the belt clip accessory. If mounting both
▶ Protection against Deep
Discharging
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the tool is switched off by means of
a protective circuit.
▶ Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable speed
trigger switch. The tool can be turned
"ON" or "OFF" by squeezing or releasing the
trigger. The speed can be adjusted from
Assembly
Only store short
screwdriver bits in the
Operating Instructions
Fig. 7
the belt clip and bit holder accessory, be
sure to place the belt clip accessory
between the bit tip holder accessory and
the tool. Always make sure you securely
tighten the mounting screw before use.
(Fig. 6).
the minimum to maximum nameplate RPM
by the pressure you apply to the trigger.
Apply more pressure to increase the speed
and release pressure to decrease speed
(Fig. 1).
▶ Brake
When the trigger switch is released it
activates the brake to stop the chuck
quickly. This is especially useful in the
repetitive driving and removal of screws.
▶ Forward/Reversing Lever and
Trigger Lock
position to help prevent accidental starts
and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located
above the trigger (Fig. 7). This lever was
designed for changing rotation of the bit,
and for locking the trigger in an "OFF"
position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far
left.
For reverse rotation move the lever to the
far right. To activate trigger lock move lever
to the center off position.
10
Fig. 6
BELT CLIP
BIT
HOLDER
After tool use, lock
trigger in "OFF"