Starting The Engine - Simpson Megashot MS61220 Manual De Uso Y Cuidado

STARTING THE ENGINE

Attempting to start the engine incorrectly or using the pressure washer incorrectly can
result in engine and/or pressure washer damage, and may cause serious injury or death.
To avoid these hazards, be sure to read, understand, and follow the steps outlined in the
OPERATING CHECKLIST section of the owner's manual before starting the engine, and
follow all the guidelines for proper use of the pressure washer.
Running the pressure washer for more than two minutes without the spray gun trigger
pulled will overheat the pump and possibly cause damage. The thermal relief valve will
open and spray water to help cool the pump as it overheats. To avoid overheating the
pump, shut off the machine if not being used for longer than two minutes.
Starting the Engine
1. Complete the steps in the OPERATING CHECKLIST, CONNECTING HOSES, and
PRIMING THE PUMP sections of this manual before starting the engine. Failure to do
so could damage your engine and pressure washer pump. If needed, refer to the engine
manual for model specific starting instructions.
2. Turn the fuel valve on. (If equipped)
3. Turn the engine ignition switch to the ON position.
4. Adjust choke as needed.
NOTE: The starting position of the choke will vary depending on the engine temperature. If
starting a cold engine, move the choke lever towards the closed position. If starting a warm
engine, move the choke lever towards the open position.
CLOSED
Page 20
OPERATING CHECKLIST
PUMP DAMAGE
MS61220/MS61221- ENGLISH
OPEN
REV 2 - 01/03/2022