Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR REFILLING OF THE FOG FLUID CANISTER
• Fog fluid should be added when the machine shows "FOG FLUID EMPTY"
• If needed follow the instructions for "Manual Control" to start up the machine again.
• Repeat the steps if the machine is not working immediately.
MAINTENANCE
•
IMPORTANT: Always set the output to Zero and wait for minimum 30 seconds before to
switch off the unit. This allows the unit to execute its cleaning process so all the remaining
fluid is removed from the internal circuits.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened and
may not be corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally
free from any deformation.
• The mains cables must be in impeccable condition and should be replaced immediately
when even a small problem is detected.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
This unit is radio-interference suppressed. This product meets the requirements of the
current European and national guidelines. Conformity has been established and the relevant
statements and documents have been deposited by the manufacturer.
Mains Input:
Power consumption:
DMX Channels:
Fuse:
Warm up time:
Fog liquid tank:
Recommended fog liquid:
Optimally usable floor area:
Water tank:
Fog liquid consumption:
Water consumption:
Dimensions (L x W x H):
Weight:
AC 220-240V, 50/60Hz
3000 Watt
2
15A
3.5 min
2.5L
BT-LOWFOG LIQUID 5L
400m2
20 liters
1-72 ml/min
185 ml/min
785 x 495 x 600 mm
52 kg
7
Publicidad
