Connect The Water Inlet And - Philips AUT3268 Manual Del Usuario

c. Drill 2 pilot holes for mounting brackets using 1/4" drill bit for the system manifold.
Note: Do not drill into anything beyond the cabinet wall.
d. Insert expansion screws and mounting screws into the wall leaving approximately 3/8"
of each screw exposed.
e. Mount the manifold on the wall to ensure it �ts properly. Then take down the manifold.
f. Remove the packaging of the �lter cartridges, insert them into the manifold according
to the order, and turn them clockwise to lock them in place.
2
PP
4. Connect the water inlet and the three-way ball valve
Insert the other end of the 1/4" pipe which has been connected with the three-way ball
valve into the water inlet hole in the back of the system. Use a clip to secure the pipe at the
hole.
Filtered water outlet
Note: The inlet water pressure should be within 0.3-0.7 MPa. If the pressure is too low,
a pressure booster should be installed prior to the system. If the pressure is too high,
a pressure relief valve should be installed prior to the system.
3
CB
RO
Tank Drain outlet
1
4 On the cover
1
Screws
2
System manifold
3
The wall
4
Water inlet
7