Care Instructions; Maintenance; Backflushing - Steinbach Premium 100 Manual Original

Stopping the pump operation
To stop the pump operation, press the ON/OFF button
deactivated.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.

Maintenance

Backflushing

Backflushing regenerates the filter and the filter sand. The filter sand must be cleaned by
backflushing prior to the initial start-up and once a week thereafter.
500 to 1100 liters of water are needed for backflushing. This water quantity
must be present before backflushing is started. The pool must be topped up
after backflushing because then there is no risk of dirt in the fresh water
supply.
Do not use an external timer. Connect the pump for the backflushing directly
to a mains outlet.
To carry out backflushing, proceed as follows:
1. Switch the pump
2. Make sure that the backflush line
3. Press and hold down the valve lever
4. Set the valve lever to the "RÜCKSPÜLEN" position and release it.
The lever engages at the "Rückspülen" position.
5. Connect the pump's power plug to the power supply.
6. Press the ON/OFF button
7. Carry out backflushing until you can see clean water through the sight glass
2 minutes).
Pay attention to the pressure indicator on the manometer. The pressure must not
exceed 1 bar during backflushing. If the pressure rises above 1 bar, clean the filter
balls.
8. Press the ON/OFF button
9. Press and hold down the valve lever
10. Set the valve lever to the "NACHSPÜLEN" position and release it.
58
off by pulling the power plug.
14
36
to switch on the pump
40
to switch off the pump
40
. The timer function is also
40
has been installed correctly.
on the valve head
37
.
14
.
14
on the valve head
37
.
1
38
.
1
(max.