Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the power
Step 1. Meeting electrical connection requirements
CAUTION
For personal safety, do not use an extension cord with this appliance. Remove the house fuse or open the circuit breaker before beginning
installation.
Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize a 4-conductor connection to an
electric range.
When installing an electric range in new construction, follow Steps 2 and 3 for a 4-wire connection.
You must use a 3-wire or 4-wire, single-phase A.C. 208Y/120 Volt or 240/120 Volt, 60 hertz electrical system.
If the electrical service provided does not meet the above specifications, have a licensed electrician install an approved outlet.
Use only a 3-conductor or a 4-conductor UL-listed range cord. These cords may be provided with ring terminals on the wire and a strain relief
device.
A range cord rated at 40 amps with 125/250 minimum volt range is required. A 50 amp range cord is not recommended but if used, it should
be marked for use with nominal 1
knockout hole to keep the edge from damaging the cable.
•
Because range terminals are not accessible after the range is in position, a flexible service conduit or cord must be used.
NOTE
If the power connection is plugged in improperly, the following message appears on the display.
•
LCD, PMOLED : Wire installation fail
•
LED : bAd LinE
Reconnect the power connection properly, and the message disappears.
ALL NEW BRANCH-CIRCUIT CONSTRUCTIONS, MOBILE HOMES, RECREATIONAL VEHICLES, AND INSTALLATIONS WHERE
LOCAL CODES DO NOT ALLOW GROUNDING THROUGH NEUTRAL, REQUIRE A 4-CONDUCTOR UL-LISTED RANGE CORD.
Install_NE63A6711_DG68-01359A-00_EN+MES.indb 3
Install_NE63A6711_DG68-01359A-00_EN+MES.indb 3
This appliance must be supplied with the proper voltage and frequency, and be connected to
an individual, properly grounded branch circuit, protected by a circuit breaker or fuse having
amperage as specified on the rating plate. The rating plate is located above the drawer on
the oven frame.
We recommend you have the electrical wiring and hookup of your range connected by a
qualified electrician. After installation, have the electrician show you where your main range
disconnect is located.
Check with your local utilities for electrical codes which apply in your area. Failure to wire
your oven according to governing codes could result in a hazardous condition. If there are no
local codes, your range must be wired and fused to meet the requirements of the National
Electrical Code, ANSI/NFPA No. 70–Latest Edition. You can get a copy by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
⁄
" diameter connection openings. Care should be taken to center the cable and strain relief within the
3
8
3 - English
2021-01-04
2021-01-04
7:08:25
7:08:25
Publicidad
