Bosch GNH 18V-64 Professional Manual Original página 19

Cordless nailer
Permitted ambient temperature during opera-
B)C)
tion and during storage
Recommended rechargeable batteries
Recommended chargers
A) Depends on battery in use
B) Limited performance at temperatures <0 °C
C) Limited performance with GBA 18V...
Noise/Vibration Information
Noise emission values determined according to EN 60745-2-16.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to EN 60745-2-16:
h
a
h
K
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Assembly
Battery Charging
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Bosch Power Tools
GNH 18V-64
°C –15 to +50
GBA 18V...
ProCORE18V...
GAL 18...
GAX 18V...
GAL 36...
GNH 18V-64
dB(A)
dB(A)
dB
2
m/s
2
m/s
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by "Electronic Cell Protection (ECP)". A protective circuit
switches off the product in which the battery is being used
when the battery is discharged. No more fasteners are dis-
charged.
Do not continue to press the trigger switch after the
u
tool has been automatically switched off. This can
damage the battery.
Follow the instructions on correct disposal.
Removing the Battery
The rechargeable battery (7) is equipped with two locking
levels to prevent the rechargeable battery from falling out if
the rechargeable battery release button (6) is pressed unin-
tentionally. The rechargeable battery is held in place by a
spring when fitted in the power tool.
– To remove the rechargeable battery (7), press the re-
lease button (6) and pull the battery out of the power
tool. Do not use force to do this.
English | 19
GNH 18V-64 M
–15 to +50
GBA 18V...
ProCORE18V...
GAL 18...
GAX 18V...
GAL 36...
GNH 18V-64 M
85
96
3
<2.5
1.5
1 609 92A 5TX | (10.05.2021)
84
95
3
<2.5
1.5