Replacing The Batteries; Replacing The Paper Roll - Sharp XE-A21S Manual De Instrucciones

4

Replacing the Batteries

This cash register displays a low battery symbol (
symbol ( ) when batteries are extremely low or batteries are not installed.
When the low battery symbol is displayed, replace the batteries with new ones as soon as possible. The
existing batteries will be dead in about two days.
When the no battery symbol is displayed, replace the batteries immediately. Otherwise, if the AC power cord is
disconnected or a power failure occurs, all the programmed settings will be reset to the default settings and any
data stored in memory will be cleared.
While the no battery symbol is being displayed, do not turn the mode switch to any positions. Follow the battery
replacement procedure below without changing the mode switch position. Otherwise, if the mode switch passes
or is set to the OFF position, all the programmed settings will be reset to the default settings and any data stored
in memory will be cleared.
Be sure to observe precautions shown on
To replace the batteries:
5

Replacing the Paper Roll

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls other than those specified could cause paper jamming, resulting in register
malfunction.
Paper specification
Paper width: 2.25 ± 0.02 in (57.5 ± 0.5 mm)
Max. outside diameter: 3.15 in (80 mm)
Quality: Thermal paper
• Be sure to set the paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful to set the roll correctly.
(How to set the paper roll)
) when the batteries are low, and displays a no battery
page 1
1.
Make sure that the cash register is plugged in.
2.
Remove the printer cover.
3.
Open the battery compartment cover next to the paper roll cradle and
remove the old batteries.
4.
Install three new alkaline batteries LR6 ("AA" size) in the battery
compartment. Be sure the positive and negative poles of each battery are
facing in the proper direction. When they are installed correctly, the "
" " symbol will disappear.
5.
Close the battery compartment cover.
6.
Replace the printer cover.
To the printer
Correct
when handling batteries.
To the printer
Incorrect
" or
71