Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
Thank you for purchasing this heater. Each unit has been manufactured to assure you
of complete safety and reliability. Before first use, please read these instructions
carefully and keep them for future reference.
INSTALLATION
This heater does not require installation, as it is a portable appliance.
It is not recommended to use these portable appliances in the bathroom.
Place the unit on a flat, unobstructed surface.
Plug the power cord into a grounded electrical outlet in your home.
OPERATION
Using the top switch, you can select the heat output (1000 or 2000W) and stop the
unit.
Right control, Start-up (speeds):
When in the "0" position it is off.
When in position "1", it is running at a power of 1000W.
When in position "2", it is running at a power of 2,000W.
Left control, Thermostat (adjustable):
If it is all the way to the left, the heater will switch off.
The further you turn the thermostat to the right, the higher the cut-out temperature
will be.
Please adjust the thermostat to obtain an optimal room temperature, as well as a high
energy saving efficiency by maintaining a comfortable temperature.
This heater is fitted with an overheat safety device, which means that if the air inlet or
outlet of the heater is accidentally covered, the overheat protector will operate,
causing the heater to shut down. In order to use the heater again, proceed as follows:
1
Publicidad
