Trouble Shooting - LUCCA HS93362 Manual De Instrucciones

TROUBLE SHOOTING

PROBLEM
There is no
power.
The heater
does not
blow any
air.
The heater
does not
work, but
Power and
Heater
settings are
"ON" and
thermostat is
set.
The heater
does not
blow warm
air.
The noise
when the
heater is on
is louder than
normal.
Abnormal
noise when
the heater
is not on
and the
flame effect
is on.
POSSIBLE CAUSE
There is no power to
the unit.
Thermostat setting
is preventing heater
from
turning on.
Manual reset
overheat
protection
triggered.
The heater is in a
cool down cycle.
The air intakes
a.
are dirty or
obstructed.
The blower/
b.
heater assembly
is defective.
The Gear motor is
defective.
CORRECTIVE ACTION
Check that unit is plugged
into a standard 230V outlet.
Press the Power button
several times and make
sure the power is set to the
"ON" position.
Adjust the temperature
settings to ensure that
the thermostat is set
higher than the current
room temperature.
Turn the Power to "OFF"
and unplug the unit from
the wall outlet for 5 minutes.
After 5 minutes plug the unit
back into wall outlet, and
operate as normal. If the
problem persists contact
customer service.
This is normal operation
and the heater will continue
to run for several minutes
before shutting down.
Times will vary based on
temperatures. During this
time cool air will blow.
a. Check the air intakes for
obstructions or high dust
build up.
b. Contact Customer Service
for a new Heater/Blower
Assembly.
Contact Customer Service
for a new Gear Motor.
14