Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE APPLIANCE WITH THE BLENDER ATTACHMENT
To hold the mixer firmly and steadily, grasp it with one hand by the handle and the
other by the lower part of its body.
It is recommended to tilt the mixer at a slight angle to prevent the blender
attachment from being sucked into the bottom of the container. Before starting
the mixer, make sure that the blender attachment is sufficiently submerged to
avoid splashing food. It is recommended to immerse 2/3 of the blender attachment
in the vessel.
USING THE APPLIANCE WITH THE WHISK ATTACHMENT
When whisking, it is recommended to move the mixer so that the whisk moves
around in the bowl. This will make it possible to produce a homogeneous mixture
from the mixed ingredients. Do not touch the sides of the bowl with the whisk. It
is recommended to dip at least 1/5 of the whisk into the bowl.
3.3. Working with the device
1. Check that the ON/OFF button (C) is released, i.e. that it is in the OFF
position.
2. Connect the device to the power supply.
3. Fit the whisk or blender attachment into the body of the appliance.
4. Press the safety button (A) (not applicable to models: RCSM-280AV, RCSM-
280AV-1).
5. Press the ON/OFF button (C), and hold it down while the mixer is running.
The mixer will run until the ON/OFF button is released.
CAUTION! Before starting, make sure that the speed control knob is set to
the lowest speed (turned to the left as far as possible).
6. To change the mixer speed, turn the speed control knob (B) in the desired
direction. Turning the knob clockwise (+) will increase the speed and
counter-clockwise (-) will decrease it.
CAUTION! Use the mixer with the whisk attached at the lowest speed!
7. Continuous operation mode (not applicable to models: RCSM-280AV,
RCSM-280AV-1): for the device to operate without holding down the
button, the lock button (D) must be pressed after starting (pressing the
ON/OFF button). The ON/OFF button (C) can then be released. The device
will operate continuously. To stop the mixer (and exit continuous operation
mode) press and release the ON/OFF button - this will switch off the lock
and the mixer.
8. When finished, release the ON/OFF button. Wait for the rotating parts to
stop and then disconnect the mixer from the power supply.
Publicidad
