Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
14. 5 Pin Control Socket
1 . 5
Gas/electricity integrated interface
16. Negative Welding Terminal
17. Power switch
18. Gas input port
CAUTION
3.2 Setup for STICK (MMA) welding
B e f o r e connect i ng t h e w o r k c l a m p t o t h e wor k a n d
inserting the electrode in the electrode holder make
ARNING
sure the mains power supply is switched off.
Remove any packaging material prior to use. Do not
block the air vents at the front or rear of the Welding
CAUTION
Power Source.
L o o s e w e l d i n g t e r m i n a l c o n n e c t i o n s c a n c a u s e
overheating and result in the male plug being fused
CAUTION
in the bayonet terminal.
48
.
3.3 Set-up for HF TIG (GTAW) welding
NOTE
Before any welding is to begin, be sure to wear all
appropriate and recommended safety equipment.
ARNING
Operation
49
Publicidad
