Descargar Imprimir esta página

Joie i-Level Recline Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
Installation with base
see images
-
1
10
1. Fit the ISOFIX guides with the ISOFIX anchor points.
guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
2. Unfold the load leg from storage compartment.
3. Line up the ISOFIX connectors with the ISOFIX guides, and then
click both ISOFIX connectors into the ISOFIX anchor points.
!
Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. There should be two audible clicks and
the colors of the indicators on the both ISOFIX connectors should be
-1
completely green.
3
!
Check to make sure the base is securely installed by pulling on the
both ISOFIX connectors.
4. After placing the base on the vehicle seat, extend the load leg to
floor
, When the load leg indicator shows green means it is
4
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
5. The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
ISOFIX anchor points.
5
!
The load leg must be installed correctly with green indicator.
6. Push the infant carrier module down into the base
child restraint is secure, the shell indicator shows green.
!
Pull up on the infant carrier module to be sure it is securely latched
into the base.
5
The ISOFIX
1
2
4
5
-1
, if the infant
6
7. Press the base release button and push the base back against the
vehicle seat until tight.
8. To release the infant carrier module
module off while press the infant carrier module release button.
9. To remove the base, press the secondary lock button
then the button
base from the vehicle seat.
3
-3
-2
5
7
8
-2
, lift the infant carrier
9
-2
on the ISOFIX connectors before removing the
10
10
-1
9
-1
first and
10
6

Publicidad

loading

Este manual también es adecuado para:

I-gemm 3I-snug 2I-juva