Introduction; Installation - Behringer X-MADI Guia De Inicio Rapido

Ocultar thumbs Ver también para X-MADI:

Idiomas disponibles

1. Introduction

The X-MADI card is a multichannel audio interface expansion

card for the X32 series of digital mixers. It provides 32 channels

of MADI/AES10 input and output via fibre-optic or coaxial cables.

This provides very long cable runs up to 2 km with fiber-optic

connection and allows redundancy when combined with BNC

coaxial connectors.

Before you install the X-MADI card in the expansion slot of the

X32 console, you must check behringer.com to verify whether the

console firmware supports that card.

Caution – before installing the X-MADI card into the console,

you must make sure that the console's power switch is turned off.

Malfunctions or electrical shock may occur otherwise.

Make sure that the mixer's power is turned off.

Loosen the screws left and right that fasten the slot,

then remove the slot cover or currently-installed card and

keep it in a safe place.

Before removing the X-MADI card from its protective bag,

we recommend touching the grounded metal chassis of the

console to prevent electrostatic discharges affecting the

sensitive electronic components. It is generally a good idea

to hold the card either by the face plate or by the two small

handles, but never touching the components on the circuit

board directly.

Align both edges of the card with the guide rails inside the

slot and carefully insert the card into the slot. Push the card

all the way into the slot to ensure that the contacts of the

card are correctly inserted into the connector inside.

All manuals and user guides at all-guides.com

Requirements

X32 Series console with firmware version 2.0 or higher.

Fasten the card using the included screws. Be aware that

damage or malfunctions may occur if the card is

not fastened.

Quick Start Guide

Tabla de Contenido