Control Panel Instructions - Easy Home EPA080BAUW Manual Del Usuario

Installation
Continuous drain
During the DRY mode, you may wish to set up the
continuous drain option so that the unit will automati-
cally drain collected water.
Remove the exhaust hose during DRY mode, it is
not necessary. Ensure that the unit is turned off and
unplugged from the power source before setting up
the drain hose.
Remove the upper drain plug and attach a 3/4" drain
hose. Ensure that there are no kinks or bends in the
drain hose as this can stop water from draining.
Place the open end of the drain hose over the re-
ceptacle that the unit will drain into; this could be a
basement fl oor drain, a sink or similar.
Remember that there is no drain pump in this unit,
the continuous drain is activated by gravity only.
Ensure that the drain hose goes straight down toward
the fl oor from the drain connection. If the hose is not
positioned directly downwards, water will not drain
correctly.
14

Control panel instructions

Cool
Fan
Dry
Mode button: Press to select the desired mode. Modes
will cycle in sequence with each press of the button;
COOL, DRY, FAN. Light will indicate current mode. Fan
speed can be chosen on COOL and FAN modes using
the remote control.
COOL mode
- Press the mode button until the COOL icon illuminates
- Press the UP or DOWN arrow buttons to select the
desired room temperature
- The temperature can be set within a range of 17-30°C
/ 62-86°F
Note: The hose should be exhausted during COOL
mode
FAN mode
- Press the mode button until the FAN icon illuminates
- Fan speed can be adjusted using the remote control
DRY mode
- Press the mode button until the DRY icon illuminates
- The display will show the current room temperature
- Fan speed and temperature cannot be adjusted in this
mode
Up and Down buttons: Used to adjust temperature
settings in COOL mode. Press and hold both Up and
Down buttons for 3 seconds to change the temperature
display from °C to °F.
Operation
POWER
15