Publicidad
Idiomas disponibles
Idiomas disponibles
MB-5401360_Bediene.qxd
• Avoid frequent blocking when drilling,
tightening or loosening screws.
• Connect the charger only to a
200–240 V AC power supply.
• Charge the screwdriver battery only
with the charger supplied.
• Protect the charger and the
screwdriver from contact with
moisture. Never immerse in water!
• Do not use the charger in the open
air.
• To avoid damage to the batteries,
never expose them to temperatures of
over 50 °C.
CAUTION! Do not short-circuit
the contacts of the battery or
charger.
• When charging, ensure that the
device is correctly connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be
replaced. In case of damage, dispose
of the device in the correct manner. In
case of damage, dispose of the
device in the correct manner.
Safety notes for battery/charger
• Keep the charger away from rain or
damp. Water entering into the
charger will increase the risk of an
electrical shock.
• Keep the charger clean.
Contamination will increase the risk of
an electrical shock.
• Check the charger, cable and plug
60
each time you use the unit. Do not
16.11.2009 16:02 Uhr
All manuals and user guides at all-guides.com
Seite 60
use the charger if you find any
damages. Never open the charger
up yourself, have it repaired by a
qualified specialist only and with
original replacement parts. A
damaged charger, cable or plug will
increase the risk of an electrical
shock.
• Never operate the charger on a
surface that will burn easily (for
example, paper, textiles etc) or in a
flammable environment. There is a
risk of fire occurring as a result of the
heat generated during the charging
process.
• Do not open the battery. There is a
risk of short-circuiting.
• In the event of damages and
incorrect use, vapours may come
out of the battery. Ensure plenty of
fresh air and, if you have any
symptoms, consult a doctor. These
vapours may irritate the respiratory
system.
7 – Charging battery
This battery-powered screwdriver
BAS 180-2B may only be charged
using the XR-DC240400B mains
adapter unit. The mains adapter unit
may only be operated with a power
supply that has an alternating current
of 200-240 V and a frequency of 50 Hz.
The use of any other mains adapter
units or the use of the XR-DC240400B
with another type of power supply may
lead to personal and property damage.
The rechargeable battery is not fully
charged on leaving the factory. Charge
the rechargeable battery before first use.
Withdraw rechargeable battery (5) from the
storage battery drill screwdriver (Fig. 2).
Publicidad
