Braun Silk-expert Mini PL1 Manual De Instrucciones página 18

Side effect
Warm feeling or tingling sensations during treatment, which
typically disappear after a few seconds to a minute and
decrease with continued use.
Discomfort or pain is intense during treatment or persists
after a treatment.
Skin redness during or after treatment which disappears
within minutes to several hours.
Skin redness which does not go away within
24 - 48 hours after treatment.
In very rare cases:
Swelling and redness around the hair follicle that
disappears within two or three days.
Swelling and redness around the hair follicle that does not
disappear within two to three days.
Temporary changes in skin color (lightening or darkening).
Increase in hair growth in areas of treatment (more likely to
be seen with subjects of Mediterranean descent).
Trouble shooting
The following troubleshooting guide may help you solving initial problems you may experience with this device.
Problem
Power indicator (4) does not light up when treatment
window is placed on the skin.
Flashing sequence slows down.
Red power indicator light
Red flashing indicator light
Power indicator light flashes alternately red and white.
The device is broken, cracked or appears defective.
Disposal
The product contains recyclable electronic waste. To protect the environment, do not dispose of it in the household
waste, but take it to appropriate local collection points.
18
How to assess and react
This is expected and normal for all IPL treatments. You can
keep on using the device as instructed.
Stop using the device and consult your physician before
using it again.
This is expected and normal for all IPL treatments. You can
keep on using the device as instructed once skin redness
has disappeared.
Stop using the device and consult your physician before
using it again.
You can keep on using the device as instructed once swelling
and redness around the hair follicle has disappeared.
Stop using the device and consult your physician before
using it again.
If your skin color changes, stop using the device and
consult your physician.
If this increase persists over several treatments, stop using
the device and consult your physician.
Solution
Make sure the device is connected to an electrical outlet.
Press the treatment button to activate it. Ensure that the
entire treatment window area touches the skin. If needed,
move the device to improve skin contact.
Device is in heat-protection mode. To get back to normal
speed, allow device to cool down.
Invalid skin tone reading. Your skin is either too light or too
dark. Device will not flash.
Device error. Device will not operate. Unplug and reconnect.
If error persists, contact a Braun Service Centre for repair.
End of product lifetime. Maximum number of flashes
(300.000) has been reached.
Do not use if the handle, the base station or the mains cord
is damaged. If you are in any doubt about the safety or
suspect it is damaged in any way, you must not use it.